Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY
+ / - Hover over image to Zoom
Other Views
Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 0 Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 1 Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 2 Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 3 Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 4 Thumbnail Image for Tele-Sun Shade Flush Mount Aluminum Rod Holder 10 Degree #F31-0702BXY 5

Flush Mount Rod Holder
10°

Item # 205431

Gain access to pricing, inventory, and online ordering by becoming a customer today.
Click here to apply!

Description

Use this 10-degree flush mount rod holder with Tele-Sun Marine Shade Poles in Carbon Fiber (#205432) to create quick and easy marine deck shade. The rod holder features a round flange and welded pin design. Not compatible with Tele-Sun Marine Shade Poles in Aluminum (#205433). Highlights:

  • Bladeless weld-on rod holder
  • Great for marine shade fly, T-tops, towers, radar arches, railings, and leaning posts
  • Welded I-beam securely seats rod butt
  • Includes a form-fitted anti-fungal PVC white liner
  • 5-year limited warranty
  • Made in the USA


How to install:

1) The lower base tube is at a 10° angle. If mounting the holder in the stern, the base tube should be inserted through the gunnel with the butt-end of the tube toward the bow. Vice versa if mounting in the bow.
2) Place masking tape on the surface to protect the area where the hole will be drilled to help prevent damage from drill slippage.
3) Measure and mark the location where the base is to be mounted.
4) The elliptical hole should be cut at 10° to the gunnel or mounting surface.
5) Drill the area with a hole saw at a 10° angle. Verify there are no wires or obstructions under the area being drilled.
6) After the 10° elliptical hole is drilled, enlarge the hole with a rasp file to allow for a good fit.
7) Once fit is verified, align the base in the desired direction, place it flat on the mounting surface, mark each bolt hole, remove the rod holder, and drill the bolt holes.
8) Remove tape and clean surface.
9) Install marine-grade sealant (3M-5200 or equivalent) between the mounting surface and the base.
10) Install and tighten bolts, washers, and nuts.

Flange width: 3-1/2". Rod holder height: 5-1/2". Angle: 10°.

Specifications

Product Category:
Rod Holder
Style#:
F31-0702BXY
Material:
Aluminum
Size:
Flange width: 3-1/2 in., Tube: 5-1/2 in., Angle: 10°.