Image for Head Rod Molding #37 Aluminum 20'
+ / - Hover over image to Zoom
Other Views
Thumbnail Image for Head Rod Molding #37 Aluminum 20' 0

Head Rod Molding #37 Aluminum 20'

Item # 251040

Gain access to pricing, inventory, and online ordering by becoming a customer today.
Click here to apply!


Use this awning molding for installations at the head of stationary or patio awnings and for installation and adjustment of the rafters of patio awnings. Also called trailer molding, awning rail, or awning track, this #37 awning molding is made from extruded 6063-T6 aluminum with a mill finish.

#37 Head Rod Moldings are designed for use with a 1/2-inch diameter conventional head rod to eliminate the awkward job of threading a rope-filled hem through a slot in the molding. The head rod is merely placed in position and finger clips are tightened to hold the head of the awning under the rainproof lip of the molding. The finger clips ride in a track in the molding and can be adjusted to move laterally right or left. This awning rail is 20 feet long.

The advantage of this system is that rafters can be placed precisely, even if the surface is uneven or the mounting supports are not located where the rafters should be, because once the molding is mounted, the rafters can be slid to their proper location.

Installation guidelines:

Recommended rafter spacing is 1-1/2 feet in from each side, and then 3 feet to 4 feet centers depending on projection (the longer the rafters, the less the spacing). Awning rafters are attached to special jaw ends that are mounted in a track in the lower side of the molding. The jaw ends can be moved laterally to adjust the rafter width. This is done by turning or tightening the jaw end, which is fitted with a carriage bolt to ride in the same track as the finger clip. The awning molding itself is designed so that a bead of caulking compound can be applied to the top length of the molding to prevent water from leaking behind the molding and down the wall.

Trademark: Trivantage® is a registered trademark of Glen Raven, Inc.

Info & Guides - Click to Download

No downloads are currently available for this product.


Product Category:
Molding - Head Rod Molding No. 35/37
20 ft.