Trivantage® Slip-Fit fittings, made of sturdy, plated, shockproof malleable iron, or plated steel as shown, offer a time and labor saving way to install patio awnings. No threading necessary, as all fittings simply slip on or over pipe frame, and are then secured by means of square head set screws. Slip-Fit fittings permit rapid adjustment when pipe is not cut to exact length.
A fitting made of plated steel clamps and zinc die-cast collar, with many applications where a sturdy reinforced assembly is required. Ideal for patio awning pipe frame assemblies, supporting pipe posts, pipe braces, and all types of special pipe frames.
The interlocking three-piece fitting provides a rigid, low cost assembly. Slip top section over pipe and adjust to desired position. Tighten set screw. Both hands are free to quickly bolt interlocking bottom section to top section for completed assembly.
Tolerance on sand casting: 1/32 inch to 4 inch dimension, 3/64 inch to 4 inch to 8 inch dimension. Tolerance on die casting: ± 0.005 inch.